During the normal operation of the diesel generator set, will the YC6A230L-D20 produce normal mechanical losses, causing other problems such as carbon deposits in the Yuchai diesel generator set? Many customers have said that they have been seriously troubled by carbon deposits. Too much will seriously affect the efficient operation of the equipment, so contact Fengyue Power to find a solution, so how to clean up the diesel generator carbon deposits? What's the trick? The following Fengyue Power will give you a brief introduction:

1. The mechanical method is adopted: if the carbon deposits around the nozzle holes of the fuel injector are removed, a fine copper wire brush can be used. However, the mechanical method of removing carbon deposits has low work efficiency and poor removal quality. It is difficult to scrape some parts, and many small scratches will be left, which will become the growth point of new carbon deposits and damage the roughness of the parts. Therefore, this method is not suitable for parts with high precision.

2. Core spraying method: a method of spraying crushed walnut, peach, and apricot core-shell particles to the surface of parts by high-speed air flow to remove carbon deposits. This method is high in efficiency and clean in addition to carbon deposition, but it requires special equipment to form a high-speed airflow, and the relative cost is relatively high, so it should not be widely used.

3. Chemical method: Use a chemical solvent-decarburizing agent to soften the carbon deposit on the surface of the parts. There are many types of decarburizing agents. For example, according to different metal parts materials, they are divided into decarburizing agents for steel parts and decarburizing agents for aluminum parts. This is because some decarburizing agents contain components that have a chemical corrosion effect on aluminum products (such as caustic soda), so they are only suitable for decarburizing steel. First-distilled diesel 40%, soft soap 20%, mixed powder 30%, triethanolamine 10%, put the parts into a sealed container during use, heat with steam to 80~90℃, soak for 2~3 hours, the formula is suitable for metal No corrosion effect.

In the process of cleaning up carbon deposits, we can choose specific solutions based on comprehensive consideration of the formation reasons, locations and our own conditions of carbon deposits. Everyone must clean up the carbon deposits regularly. Do not wait until the carbon deposits reach a certain level before cleaning up. This will not only greatly reduce the efficiency of the diesel generator, but also increase the difficulty of cleaning up.